1、Every day after work, the machine is turned on to the maximum lubrication width opening screw guide rail.
2、Increase the compression thickness to the maximum every day and observe if the water pipe is blocked.
3、Before leaving work every day, the machine needs to be wiped clean, and the interior and surrounding broken glass of the machine should be cleaned. There should be no dust, oil, or impurities left on the machine.
4、Before starting the machine every day, it is necessary to open and close the machine to the minimum and maximum positions, and at the same time, manually pull the oil pump several times to lubricate the grinding head carriage.
5、After working every day, turn the keyway of the main transmission shaft downwards, wipe it clean, and apply engine oil.
6、：Check for water and dust on the optical sensor every week and wipe it clean to avoid affecting normal work.
7、Clean the dust inside the electrical cabinet with a gas pipe every month;
8、 Replace the lubricating oil at the transfer gearbox bearing position every three months, and open the width opening cover every month to check the lubricating oil condition of the screw guide rail;
9、： During the long holiday, both sides of the Double-sided edging machine need to turn off the water and start the machine to idle for one hour;
10、Change the cooling water every 48 working hours and clean the glass powder and impurities in the water tank to avoid affecting the polishing quality.
11、Regularly check all oil pumps for oil shortage.
12、After the first 200 hours of operation of the worm speed reducer, the lubricating oil needs to be replaced; Replace every 3000 hours of operation in the future, with the lubrication oil level reaching the middle of the oil immersion lens and not exceeding it.
13、Regular maintenance of bearings for high-speed running components.
14、Regularly refuel the servo safety corner dubbing screw and guide rail pressure hand pump.
15、The cleaning machine needs to clean the glass powder in the water tray at the feed end every week.
16、In order to ensure the normal operation of the machine and extend its service life, good maintenance and upkeep must be carried out